Inspection [11/2016 - ]: Procedure
- INSPECT CLOCK ASSEMBLY
- Apply battery voltage to the clock assembly and check that the indicator light illuminates.
*A for Captain Seat Type *B for 60/40 Split Seat Type *a Security Indicator Light *b Rear seat belt warning light (rear No. 1 seat LH) *c Rear seat belt warning light (rear No. 1 seat center) *d Rear seat belt warning light (rear No. 1 seat RH) *e Rear seat belt warning light (rear No. 2 seat LH) *f Rear seat belt warning light (rear No. 2 seat center) *g Rear seat belt warning light (rear No. 2 seat RH) *h Component without harness connected
(Clock Assembly)OK
Battery Connection Specified Condition Battery positive (+) → Terminal 9
Battery negative (-) → Terminal 8Security indicator light comes on Battery positive (+) → Terminal 11
Battery negative (-) → Terminal 8Rear seat belt warning light (rear No. 1 seat RH) comes on Battery positive (+) → Terminal 12*
Battery negative (-) → Terminal 8*Rear seat belt warning light (rear No. 1 seat center) comes on Battery positive (+) → Terminal 13
Battery negative (-) → Terminal 8Rear seat belt warning light (rear No. 1 seat LH) comes on Battery positive (+) → Terminal 5
Battery negative (-) → Terminal 8Rear seat belt warning light (rear No. 2 seat RH) comes on Battery positive (+) → Terminal 6
Battery negative (-) → Terminal 8Rear seat belt warning light (rear No. 2 seat center) comes on Battery positive (+) → Terminal 10
Battery negative (-) → Terminal 8Rear seat belt warning light (rear No. 2 seat LH) comes on - *: for 60/40 Split Seat Type
If the result is not as specified, replace the clock assembly.
- Apply battery voltage to the clock assembly and check that the indicator light illuminates.