LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Camry LE >> Repair and Diagnosis >> Restraints >> Seat Belts >> Pre-Collision System (Diagnostic Codes (C1A01-U0235) & Circuit Tests) (Except Hybrid) >> Pre-Collision System >> DTC U0235: Lost Communication with Cruise Control Front Distance Range Sensor; DTC U1002: Lost Communication with Gateway Module; DTC U1104: Lost Communication with Driving Support ECU [08/2015 - ] >> Inspection Procedure

Inspection Procedure

NOTE:
  • When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed. Refer to ADJUSTMENT [08/2015 - ] .
  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  • When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.
scientia non olet · About LEMON Manuals