Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL:
| The monitor will run whenever this DTC is not present | None |
| Solenoid current cut status | Not cut |
| Engine switch | on (IG) |
| Starter | OFF |
MALFUNCTION (A):
| Battery voltage | 12 V or more |
| Target current | 1 A |
MALFUNCTION (B):
| Battery voltage | 10 V or more and less than 12 V |
| Target current | 0.75 A |
MALFUNCTION (C):
| Battery voltage | 8 V or more |
| Target current | 1 A |
MALFUNCTION (D):
| Battery voltage | 11 V or more |
| Target current | 1 A or more |
MALFUNCTION (E):
| Battery voltage | 11 V or more |
| Target current | 0.1 A or more |
| Difference between target voltage and last target voltage | Less than 0.0000191 V |