TRAC OFF Indicator Light does not Come ON [08/2015 - ]: Procedure

1. Check if a CAN communication system DTC is output. Refer to DIAGNOSIS SYSTEM [08/2015 - ] .

   Result

   Result	Proceed to
   DTC is not output.	A
   DTC is output.	B

B → See step   6 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Start the engine.
3. Select the Active Test on the Techstream. Refer to DATA LIST / ACTIVE TEST [08/2015 - ] .
   ABS/VSC/TRAC
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   TRC(TRAC) OFF Indicator Light	TR(A)C OFF indicator light*1 Multi-information display (TR(A)C OFF message)*2	Indicator light ON/OFF*1 Display (message) ON/OFF*2	Observe combination meter assembly

   • *1: w/o Multi-information Display
   • *2: w/ Multi-information Display
4. Check that the TR(A)C OFF indicator light (w/o Multi-information Display) or the multi-information display (w/ Multi-information Display) on the combination meter assembly turns on or off in accordance with the Techstream operation.

   OK

   The TR(A)C OFF indicator light (w/o Multi-information Display) or the multi-information display (w/ Multi-information Display) turns on or off in accordance with the Active Test operation.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts. Refer to PROBLEM SYMPTOMS TABLE [08/2015 - ] .

NG → See step   3 

OK → See step   4 

1. Turn the ignition switch off.
2. Perform an Active Test of the combination meter assembly (meter CPU) using the Techstream. Refer to DATA LIST / ACTIVE TEST [08/2015 - ] .
3. Check the combination meter assembly.

   OK

   The TR(A)C OFF indicator light (w/o Multi-information Display) or the multi-information display (w/ Multi-information Display) turns on or off in accordance with the Active Test operation.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts. Refer to PROBLEM SYMPTOMS TABLE [08/2015 - ] .

NG → See step   5 

OK → See step   4