Slip Indicator Light does not Come ON [08/2015 - ]: Procedure

1. Check if a CAN communication system DTC is output. Refer to DIAGNOSIS SYSTEM [08/2015 - ] .

   Result

   Result	Proceed to
   DTC is not output.	A
   DTC is output.	B

B → See step   4 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Start the engine.
3. Select the Active Test using the Techstream. Refer to DATA LIST / ACTIVE TEST [08/2015 - ] .
   ABS/VSC/TRAC
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Slip Indicator Light	Slip indicator light	Indicator light ON/OFF	Observe combination meter assembly

4. Check that the slip indicator light on the combination meter assembly turns on or off in accordance with the Techstream operation.

   OK

   The slip indicator light turns on or off in accordance with the Active Test operation.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts. Refer to PROBLEM SYMPTOMS TABLE [08/2015 - ] .

NG → See step   3 

OK → See step   5 

1. Turn the ignition switch off.
2. Perform an Active Test of the combination meter assembly (meter CPU) using the Techstream. Refer to DATA LIST / ACTIVE TEST [08/2015 - ] .
3. Check the combination meter assembly.

   OK

   The slip indicator light turns on or off in accordance with the Active Test operation.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts. Refer to PROBLEM SYMPTOMS TABLE [08/2015 - ] .

NG → See step   6 

OK → See step   5