ABS Warning Light does not Come ON [08/2015 - ]: Procedure

1. Check if a CAN communication system DTC is output. Refer to DIAGNOSIS SYSTEM [08/2015 - ] .

   Result

   Result	Proceed to
   DTC is not output.	A
   DTC is output.	B

B → See step   4 

A: Go to next step 

1. Disconnect the skid control ECU connector.
2. Turn the ignition switch to ON.
3. Check that the ABS warning light comes on.

   OK

   The ABS warning light comes on.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts. Refer to PROBLEM SYMPTOMS TABLE [08/2015 - ] .

NG → See step   3 

OK → See step   5 

1. Turn the ignition switch off.
2. Reconnect the skid control ECU connector.
3. Perform an Active Test of the combination meter assembly (meter CPU) using the Techstream. Refer to DATA LIST / ACTIVE TEST [08/2015 - ] .
4. Check the combination meter assembly.

   OK

   The ABS warning light turns on or off in accordance with the Active Test operation.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts. Refer to PROBLEM SYMPTOMS TABLE [08/2015 - ] .

NG → See step   6 

OK → See step   5