Rear Power Window RH does not Operate with Rear Power Window Switch RH [08/2015 - ]: Procedure

1. Disconnect the L7 rear power window regulator switch assembly (for RH door) connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   L7-2 (B) - Body ground	Ignition switch ON	11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Remove the rear power window regulator switch assembly (for RH door). Refer to REMOVAL [08/2015 - ] .
2. Inspect the rear power window regulator switch assembly (for RH door). Refer to INSPECTION [08/2015 - ] .

NG → See step   6 

OK: Go to next step 

1. Disconnect the L5 power window regulator motor assembly (for rear RH door) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   L7-7 (U) - L5-1 (U)	Always	Below 1 Ω
   L7-7 (U) or L5-1 (U) - Body ground	Always	10 kΩ or higher
   L7-1 (D) - L5-2 (D)	Always	Below 1 Ω
   L7-1 (D) or L5-2 (D) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Remove the power window regulator master switch assembly. Refer to REMOVAL [08/2015 - ] .
2. Inspect the power window regulator master switch assembly. Refer to INSPECTION [08/2015 - ] .

NG → See step   8 

OK: Go to next step 

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   K11-10 (RRU) - L7-3 (SU)	Always	Below 1 Ω
   K11-10 (RRU) or L7-3 (SU) - Body ground	Always	10 kΩ or higher
   K11-16 (RRD) - L7-4 (SD)	Always	Below 1 Ω
   K11-16 (RRD) or L7-4 (SD) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   7