DTC C1AE4: Front Right Sensor Malfunction [08/2015 - ]: Procedure
- CHECK DTC OUTPUT
- Check for DTCs. Refer to DTC CHECK / CLEAR [08/2015 - ]
.
Result
Result Proceed to Only DTC C1AE4 is output A DTC C1AE4 and C1AEC are output B No DTCs are output C
B → See step 6
C → See step 5
A: Go to next step
- Check for DTCs. Refer to DTC CHECK / CLEAR [08/2015 - ]
.
- REPLACE NO. 1 ULTRASONIC SENSOR (FRONT RIGHT SENSOR)
- Replace the No. 1 ultrasonic sensor (front right sensor) with a known good one. Refer to REMOVAL [08/2015 - ]
.
HINT:
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
NEXT: Go to next step
- Replace the No. 1 ultrasonic sensor (front right sensor) with a known good one. Refer to REMOVAL [08/2015 - ]
.
- CHECK DTC OUTPUT
- Clear the DTCs. Refer to DTC CHECK / CLEAR [08/2015 - ] .
- Check for DTCs. Refer to DTC CHECK / CLEAR [08/2015 - ]
.
Result
Result Proceed to No DTCs are output OK DTC C1AE4 is output NG
NG → See step 4
OK → END (FRONT RIGHT SENSOR WAS DEFECTIVE)
- REPLACE CLEARANCE WARNING ECU ASSEMBLY. Refer to REMOVAL [08/2015 - ]
- USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ]
- GO TO DTC (C1AEC). Refer to DTC C1AEC: Front Sensor Communication Malfunction [08/2015 - ]