Panel Switches do not Function [08/2015 - ]: Procedure
- CHECK PANEL SWITCH
- Check for foreign matter around the switches that might prevent operation.
OK
No foreign matter is found.
NG → REMOVE ANY FOREIGN MATTER FOUND
OK: Go to next step
- Check for foreign matter around the switches that might prevent operation.
- CHECK PANEL & STEERING SWITCH (OPERATION CHECK)
- Enter the "Panel & Steering Switch Check Mode" screen.
Refer to Check Panel & Steering Switch in Operation Check. Refer to OPERATION CHECK [08/2015 - ] .
- Operate the abnormal switch and check if the switch status is correctly displayed.
OK
The switch status is correctly displayed as operated.
NG → See step 3
OK → See step 4
- Enter the "Panel & Steering Switch Check Mode" screen.
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [08/2015 - ]
- REPLACE NAVIGATION RECEIVER ASSEMBLY. Refer to REMOVAL [08/2015 - ]