Display does not Dim when Light Control Switch is Turned ON [08/2015 - ]: Procedure
- CHECK IMAGE QUALITY SETTING
- Turn the light control switch to the tail or head position.
- Check that the daytime screen setting on the display adjustment screen is set to on.
Result
Result Proceed to Daytime screen setting is set to on. A Daytime screen setting is set to off. B
B → See step 2
A → CHANGE DAYTIME SCREEN SETTING TO OFF
- CHECK VEHICLE SIGNAL (OPERATION CHECK)
- Enter the "Vehicle Signal Check Mode" screen.
Refer to Check Vehicle Signal in Operation Check. Refer to OPERATION CHECK [08/2015 - ] .
- Check that the display changes between ON and OFF according to the light control switch operation.
OK
Light Control Switch Display Tail or head ON Off OFF HINT:
The display is updated once per second. It is normal for the display to lag behind the actual switch operation.
NG → See step 3
OK → See step 4
- Enter the "Vehicle Signal Check Mode" screen.
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [08/2015 - ]
- REPLACE NAVIGATION RECEIVER ASSEMBLY. Refer to REMOVAL [08/2015 - ]