CD cannot be Inserted or is Ejected Right After Insertion [08/2015 - ]: Procedure

1. Make sure that the CD is an audio CD or a CD with an MP3, WMA or AAC files, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.

   OK

   Normal CD.

   HINT: 

   • Translucent or uniquely-shaped CDs cannot be played.
   • CDs with adhesive paper labels should not be played.
   • Commercial audio CDs can be played.
   • CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.
   • MP3, WMA and AAC files on CD-ROMs, CD-Rs and CD-RWs can be played.
   • For details on playable CDs, refer to Owner's Manual.

NG → CHANGE CD 

OK: Go to next step 

1. Check the CD is inserted upside down.

   OK

   CD is properly inserted.

NG → INSERT CD PROPERLY 

OK: Go to next step 

1. Clean the CD by wiping it clean with a soft cloth from the inside to the outside in a radial direction.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK

   Malfunction disappears.

   NOTE:

   Do not use a conventional record cleaner or anti-static preservative.

NG → See step   4 

OK → END (CD WAS DIRTY) 

1. Replace the CD with a new or known good one and check that the malfunction disappears.

   OK

   Malfunction disappears.

NG → See step   5 

OK → END (CD WAS FAULTY)