DTC B15F7: Certification ECU Vehicle Information Reading/Writing Process Malfunction [08/2015 - ]: Procedure
- CHECK CAN COMMUNICATION SYSTEM
- Use the Techstream to check if the CAN communication system is functioning normally. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ]
.
OK
CAN communication DTCs are not output.
NG → See step 5
OK: Go to next step
- Use the Techstream to check if the CAN communication system is functioning normally. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ]
.
- CHECK SMART KEY SYSTEM
- for Entry Function:
Check if the smart key system is malfunctioning. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] .
for Start Function:
Check if the smart key system is malfunctioning. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] .
HINT:
Customization may not be possible depending on the malfunction in the smart key system.
OK
No malfunctions are present in the smart key system.
Result
Result Proceed to OK A NG (for Entry Function) B NG (for Start Function) C
B → See step 6
C → See step 8
A: Go to next step
- for Entry Function:
- CHECK CUSTOMIZE ITEMS
- Make a note of the customizable items for the certification ECU (smart key ECU assembly) related system.
HINT:
The items shown as customizable via the navigation system vehicle customization screen can also be changed using the Techstream. In the following step, the Techstream will be used.
- To match-up the items on the navigation system vehicle customization screen with the items on the Techstream, check the customize parameters list for the smart key system (for Entry Function) related items that can be customized via the navigation system vehicle customization screen. Refer to CUSTOMIZE PARAMETERS [08/2015 - ] .
- To match-up the items on the navigation system vehicle customization screen with the items on the Techstream, check the customize parameters list for the smart key system (for Start Function) related items that can be customized via the navigation system vehicle customization screen. Refer to CUSTOMIZE PARAMETERS [08/2015 - ] .
- Using the Techstream, confirm that it is possible to change the settings of the customize parameters that are available for customization via the navigation system vehicle customization screen.
OK
The items available for customization via the navigation system vehicle customization screen can be customized successfully using the Techstream.
NG → See step 7
OK → See step 4
- Make a note of the customizable items for the certification ECU (smart key ECU assembly) related system.
- REPLACE NAVIGATION RECEIVER ASSEMBLY. Refer to REMOVAL [08/2015 - ]
- GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ]
- GO TO SMART KEY SYSTEM (for Entry Function). Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ]
- REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY). Refer to REMOVAL [08/2015 - ]
- GO TO SMART KEY SYSTEM (for Start Function). Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ]