DTC B15C0: Short in GPS Antenna; DTC B15C1: Open in GPS Antenna [08/2015 - ]: Procedure
- CHECK DTC
- Clear the DTCs. Refer to DTC CHECK / CLEAR [08/2015 - ] .
- Recheck for DTCs and check that no DTCs are output.
OK
No DTCs are output.
NG → See step 2
OK → See step 4
- INSPECT NAVIGATION ANTENNA ASSEMBLY
- Remove the navigation antenna assembly. Refer to REMOVAL [08/2015 - ] .
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 - 1a Always 50 to 500 Ω TEXT IN ILLUSTRATION*a Component without harness connected
(Navigation Antenna Assembly)
NG → See step 5
OK → See step 3
- REPLACE NAVIGATION RECEIVER ASSEMBLY. Refer to REMOVAL [08/2015 - ]
- USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ]
- REPLACE NAVIGATION ANTENNA ASSEMBLY. Refer to REMOVAL [08/2015 - ]