Sound Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier [08/2015 - ]: Procedure
- CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
- Disconnect the I6 navigation receiver assembly connector.
- Disconnect the I69 stereo component amplifier assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition I69-5 (R+) - I6-1 (FR+) Always Below 1 Ω I69-4 (R-) - I6-5 (FR-) Always Below 1 Ω I69-3 (L+) - I6-2 (FL+) Always Below 1 Ω I69-2 (L-) - I6-6 (FL-) Always Below 1 Ω I69-6 (SLD) - Body ground Always 10 kΩ or higher I69-5 (R+) - Body ground Always 10 kΩ or higher I69-4 (R-) - Body ground Always 10 kΩ or higher I69-3 (L+) - Body ground Always 10 kΩ or higher I69-2 (L-) - Body ground Always 10 kΩ or higher
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → See step 2
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [08/2015 - ]