Reverse Signal Circuit [08/2015 - ]: Procedure
- CHECK BACK-UP LIGHT
- Move the shift lever to R and check if the back-up lights come on.
OK
The back-up lights come on.
NG → See step 4
OK: Go to next step
- Move the shift lever to R and check if the back-up lights come on.
- CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)
- Disconnect the I67 radio and display receiver assembly connector.
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition I67-2 (REV) - Body ground Ignition switch ON
Shift lever in R11 to 14 V I67-2 (REV) - Body ground Ignition switch ON
Shift lever in any position other than RBelow 1 V
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → See step 3
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [08/2015 - ]
- GO TO LIGHTING SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ]