| Power Steering ECU Communication Stop Mode |
Either condition is met:
- "Power Steering (EPS)" is not displayed on the CAN Bus Check screen of the Techstream. Refer to PROBLEM SYMPTOMS TABLE [08/2015 - ]
- Communication system DTCs (DTCs that start with U) that correspond to "Power Steering ECU Communication Stop Mode" in "DTC Combination Table" are output. Refer to DIAGNOSIS SYSTEM [08/2015 - ]
|
- Power steering ECU assembly branch line or connector*1
- Power source circuit of power steering ECU assembly*1
- Power steering ECU assembly ground circuit*1
- Power steering ECU assembly*1
- Power steering ECU with motor assembly branch line or connector*2
- Power source circuit of power steering ECU with motor assembly*2
- Power steering ECU with motor assembly ground circuit*2
- Power steering ECU with motor assembly*2
|