SRS Warning Light does not Come ON [10/2014 - ]: Procedure

1. Measure the voltage of the battery.

   Standard Voltage

   11 to 14 V

Result: 

NG 

INSPECT CHARGING SYSTEM AND BATTERY 

(Refer to ON-VEHICLE INSPECTION [10/2014 - ] )

Result: 

OK 

See step  2

1. Turn the engine switch off.
2. Disconnect the cable from the negative (-) battery terminal.
   WARNING:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. Check that the connector is properly connected to the combination meter assembly.

   OK

   The connector is properly connected.

   HINT: 

   If the connector is not properly connected, reconnect the connector and proceed to the next inspection.

4. Disconnect the D9 combination meter assembly connector.
5. Check that the terminals of the connector are not damaged.

   OK

   The terminals are not deformed or damaged.

Result: 

NG 

REPAIR OR REPLACE CONNECTOR 

Result: 

OK 

See step  3

1. Connect the cable to the negative (-) battery terminal.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Combination Meter Assembly)

2. Turn the engine switch on (IG).
3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   D9-13 (IG+) - Body ground	Engine switch on (IG)	11 to 14 V
   D9-1 (B) - Body ground	Always	11 to 14 V

4. Turn the engine switch off.
5. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D9-7 (ES) - Body ground	Always	Below 1 Ω

Result: 

NG 

REPAIR OR REPLACE WIRE HARNESS 

Result: 

OK 

See step  4

1. Disconnect the cable from the negative (-) battery terminal.
   WARNING:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

2. Reconnect the D9 combination meter assembly connector.
3. Disconnect the D36 airbag ECU assembly connector.
4. Connect the cable to the negative (-) battery terminal.
5. Turn the engine switch on (IG).
6. Check the SRS warning light condition.

   OK

   After the primary check period, the SRS warning light goes off for approximately 10 seconds and turns back on.

   HINT: 

   The primary check operates for approximately 6 seconds after the engine switch is turned on (IG).

Result: 

OK 

REPLACE AIRBAG ECU ASSEMBLY 

(Refer to REMOVAL [10/2014 - ] )

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY 

(Refer to REMOVAL [10/2014 - ] )