LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Avalon XLE >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting System (2GR-FE) (Service Information) (Except Hybrid) >> Starter >> Installation [10/2014 - ] >> Procedure

Installation [10/2014 - ]: Procedure

  1. INSTALL STARTER ASSEMBLY 
    1. Install the starter assembly with the 2 bolts.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

    2. Connect the connector.
    3. Connect the wire harness, install the nut and close the cap.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

  2. INSTALL BATTERY 

    Refer to PROCEDURE - Step 55

  3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 56

  4. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 57

  5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 3

  6. INSTALL INLET NO. 1 AIR CLEANER 

    Refer to PROCEDURE - Step 54

  7. INSTALL INLET NO. 2 AIR CLEANER 

    Refer to PROCEDURE - Step 59

  8. INSTALL V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 82

  9. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 3 and PROCEDURE - Step 3

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [10/2014 - 10/2015] or INITIALIZATION [10/2015 - ] ).

scientia non olet · About LEMON Manuals