DTC B15C0: Short in GPS Antenna; DTC B15C1: Open in GPS Antenna [10/2014 - ]: Procedure
- CHECK DTC
- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG) and wait for 10 seconds.
- Turn the Techstream on.
- Perform "Health Check" and check for current DTCs (Refer to HEALTH CHECK [10/2014 - ]
).
Result
Result Proceed to DTC B15C0 or B15C1 is output. A DTC B15C0 or B15C1 is not output. B
Result:
B
CHECK FOR INTERMITTENT PROBLEMS
(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] or HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] )
Result:
A
See step 2
- INSPECT TELEPHONE AND GPS ANTENNA CORD (NO. 2 FLOOR WIRE)
- Disconnect the telephone and GPS antenna cord (No. 2 floor wire) connector from the DCM (Telematics Transceiver).
- Disconnect the telephone and GPS antenna cord (No. 2 floor wire) connector from the telephone and GPS antenna assembly.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition K20-2 - K21-1 Always Below 1 Ω K20-2a - K21-1a Always Below 1 Ω K20-2 - Body ground Always 10 kΩ or higher K20-2a - Body ground Always 10 kΩ or higher TEXT IN ILLUSTRATION*a Telephone and GPS Antenna Cord (No. 2 Floor Wire)
Result:
NG
REPLACE TELEPHONE AND GPS ANTENNA CORD (NO. 2 FLOOR WIRE)
Result:
OK
See step 3
- Disconnect the telephone and GPS antenna cord (No. 2 floor wire) connector from the DCM (Telematics Transceiver).
- REPLACE TELEPHONE AND GPS ANTENNA ASSEMBLY
- Replace the telephone and GPS antenna assembly with a known good one and check if the same problem occurs again (Refer to REMOVAL [10/2014 - ]
).
OK
The system returns to normal.
Result:
OK
END
Result:
NG
See step 4
- Replace the telephone and GPS antenna assembly with a known good one and check if the same problem occurs again (Refer to REMOVAL [10/2014 - ]
).
- REPLACE DCM (TELEMATICS TRANSCEIVER)
- Replace the DCM (Telematics Transceiver) (Refer to REMOVAL [10/2014 - ]
).NOTE:
- The engine switch must be off.
- Do not replace the DCM (Telematics Transceiver) with one from another vehicle.
Result:
NEXT
See step 5
- Replace the DCM (Telematics Transceiver) (Refer to REMOVAL [10/2014 - ]
).
- PERFORM PRL UPDATE
- Perform "PRL UPDATE" (Refer to PRL UPDATE [10/2014 - ] ).
Result:
NEXT
PERFORM DCM ACTIVATION
(Refer to DCM ACTIVATION [10/2014 - ] )