LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Avalon XLE >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge System - Diagnostics - Introduction - (Except Hybrid) >> Meter / Gauge System >> Data List / Active Test [10/2014 - 10/2015] >> Data List / Active Test [10/2014 - 10/2015]

Data List / Active Test [10/2014 - 10/2015]

  1. DATA LIST 

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Warm up the engine.
    2. Turn the engine switch off.
    3. Connect the Techstream to the DLC3.
    4. Turn the engine switch on (IG).
    5. Turn the Techstream on.
    6. Enter the following menus:
      1. for Combination Meter: Body Electrical / Combination Meter / Data List.
      2. for ABS/VSC/TRAC: Chassis / ABS/VSC/TRAC / Data List.
      3. for Engine and ECT: Powertrain / Engine and ECT / Data List.
      4. for Main Body: Body Electrical / Main Body / Data List.
    7. Check the values by referring to the table below.
      COMBINATION METER

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Tail Relay SW Tail relay/OFF or ON OFF: Tail relay off -
      ON: Tail relay on
      Tail Cancel SW Tail cancel switch/OFF or ON OFF: Tail cancel switch off Dimming of dash lights is possible
      ON: Tail cancel switch on Dimming of dash lights is canceled
      ODO/TRIP Change SW ODO/TRIP switch/OFF or ON OFF: Switch released -
      ON: Switch pushed
      P-Seatbelt Buckle SW Front passenger seat belt buckle switch/OFF or ON OFF: Front passenger seat belt fastened (warning light off) -
      ON: Front passenger seat belt unfastened (warning light on)
      Vehicle Speed Meter Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost same as actual vehicle speed -
      Engine Rpm Engine speed/Min.: 0 rpm, Max.: 12750 rpm 600 to 700 rpm: Idling -
      Coolant Temperature Engine coolant temperature/Min.: 0°C (0°F), Max.: 127.5°C (261.5°F) After warming up: 75 to 100°C (167 to 212°F) -
      Washer Switch Washer fluid level warning switch/OFF or ON OFF: Washer fluid level not low -
      ON: Washer fluid level low
      Check Engine SW MIL (Check engine warning light)/OFF or ON OFF: MIL (Check engine warning light) off -
      ON: MIL (Check engine warning light) on
      Multi Display Select Switch DISP switch/OFF or ON OFF: DISP switch not pressed -
      ON: DISP switch pressed
      +B Voltage Value Battery voltage/Min.: 0 V, Max.: 25.5 V 11 to 14 V -
      Integrated value for Maintenance*1 Maintenance required reminder value/Min.: 0 mile, Max.: 25500 mile Driving distance after performing maintenance required reminder reset procedure displayed If the value is 5000 (miles) or more, perform the maintenance required reminder reset procedure after performing maintenance.
      Fuel Input Fuel input/Min.: 0 L (0 US qts, 0 lmp. qts), Max.: 127.5 L (134.7 US qts, 112.2 lmp. qts) Fuel receiver gauge indicates F: 61.6 L (65.1 US qts, 54.2 lmp. qts) -
      Fuel receiver gauge indicates 3/4: 46.9 L (49.6 US qts, 41.3 lmp. qts)
      Fuel receiver gauge indicates 1/2: 32.2 L (34.0 US qts, 28.3 lmp. qts)
      Fuel receiver gauge indicates 1/4: 18.2 L (19.2 US qts, 16.0 lmp. qts)
      Fuel receiver gauge indicates E: 4.2 L (4.4 US qts, 3.7 lmp. qts)
      Rheostat value Light control rheostat value/Min.: 0 (dark), Max.: 100 (bright) Light control rheostat value 0 (dark) -
      Light control rheostat value 100 (bright)
      Oil Pressure Switch Oil pressure switch/OFF or ON OFF: Engine started -
      ON: Engine not started
      Turn Signal Switch (Right) RH turn signal switch/OFF or ON OFF: RH turn signal switch off -
      ON: RH turn signal switch on
      Turn Signal Switch (Left) LH turn signal switch/OFF or ON OFF: LH turn signal switch off -
      ON: LH turn signal switch on
      Hazard Flasher Switch Hazard warning signal switch/OFF or ON OFF: Hazard warning signal switch off -
      ON: Hazard warning signal switch on
      Key Remind Sound Cycle of the key reminder warning buzzer/Normal, Slow or Fast Normal, Slow, Fast Displays customize setting of driver side seat belt warning buzzer
      Key Remind Volume Volume of the key reminder warning buzzer/Large, Small or Medium Large, Small or Medium Displays customize setting of driver side seat belt warning buzzer
      Driver Side Seatbelt Warning Buzzer Condition of the driver seat belt warning buzzer/OFF or ON OFF: Seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened Displays customize setting of driver side seat belt warning buzzer
      ON: Seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened
      P-Seatbelt Warning Buzzer Condition of the front passenger seat belt warning buzzer/OFF or ON OFF: Seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when front passenger seat belt unfastened Displays customize setting of front passenger side seat belt warning buzzer
      ON: Seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when front passenger seat belt unfastened
      Lane Change Flashing Times Setting Condition of the lane change flashing times setting/OFF, 3, 4, 5, 6, 7 OFF, 3, 4, 5, 6, 7 Displays customize setting of lane change flashing times setting
      Number of Trouble Code The number of the DTC currently stored/Min.: 0, Max.: 255 0 to 255 -
      • *1: for Speedometer with Imperial Units
      ABS/VSC/TRAC

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Vehicle Speed Maximum wheel speed sensor reading/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
      ENGINE AND ECT

      Tester Display Measurement Item/Range Normal Condition Stored as Freeze Frame Data
      Engine Speed Engine speed/
      Min.: 0 rpm, Max.: 16383 rpm      		 600 to 700 rpm: Idling Yes
      Results of real-vehicle check:
      Idling (engine warmed up and A/C off): 660 rpm
      Diagnostic Note:
      When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed.
      Coolant Temp Coolant temperature/
      Min.: -40°C (-40°F),
      Max.: 140°C (284°F)      		 75 to 100°C (167 to 212°F): After warming up Yes
      Diagnostic Note:
      This is the engine coolant temperature.
      HINT: 
      • After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).
      • After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal.
      • If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.
      • Check if the engine overheats when the value indicates higher than 135°C (275°F).
      MAIN BODY

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Illumination Rate Info Illumination rate information/0.00 ms. to 2162.65 ms. Value output according to ambient light level -
  2. ACTIVE TEST 

    HINT: 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
    5. Check the operation by referring to the table below.
      COMBINATION METER

      Tester Display Test Part Control Range Diagnostic Note
      Speed Meter Operation Speedometer OFF, 0, 40, 80, 120, 160 mph*1 There is a deviation in the values displayed on the speedometer (*1)
      (Control range → Speedometer display)
      • 0 → 0
      • 40 → 40.0 to 43.5
      • 80 → 80.0 to 84.5
      • 120 → 120.0 to 125.5
      • 160 → 160.0 to 166.5
      OFF, 0, 40, 80, 120, 160, 200, 240 km/h*2 There is a deviation in the values displayed on the speedometer (*2)
      (Control range → Speedometer display)
      • 0 → 0
      • 40 → 38.0 to 42.0
      • 80 → 78.0 to 84.0
      • 120 → 119.0 to 125.0
      • 160 → 159.0 to 167.0
      • 200 → 199.0 to 209.0
      • 240 → 239.0 to 251.0
      Tacho Meter Operation Tachometer OFF, 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 -
      Fuel Meter Operation Fuel receiver gauge OFF, Empty, 1/2, Full -
      A/T Indicator Operation 1 Shift selector OFF, L, 2, 3(M), 4(M), D, N, R, P -
      A/T Indicator Operation 2 Shift selector OFF, 8, 5, 6, 7, Es, M, S, B -
      A/T Indicator Operation 3*3 Shift selector (D) OFF or D Sports mode
      Indicat. Lamp Airbag SRS warning light OFF or ON -
      Indicat. Lamp Doors All Open Door open warning light OFF or ON -
      Driver Side Seat Belt Driver/front passenger seat belt warning light OFF or ON -
      Indicat. Lamp ABS ABS warning light OFF or ON -
      Indicat. Lamp Charge Charge warning light OFF or ON -
      Indicat. Lamp Slip Slip indicator light OFF or ON -
      Indicat. Lamp Beam High beam indicator light OFF or ON -
      Indicat. Lamp Head*1 Head indicator light OFF or ON -
      Indicat. Lamp Tail*2 Tail indicator light OFF or ON -
      Indicat. Lamp Fr FOG*4 Front fog indicator light OFF or ON -
      Indicat. Precrash*5 PCS warning light OFF or ON -
      Indicat. Lamp Fuel Fuel level warning light OFF or ON -
      VSC TRC Indicator TRAC OFF indicator light OFF or ON -
      Indicat. Tire Pressure Warning System Tire pressure warning light OFF or ON -
      Indicat. Oil Pressure Oil pressure warning light OFF or ON -
      Indicat. ECONO*3 Eco driving indicator light OFF or ON -
      Indicat. Lamp Cruise Cruise main indicator light OFF or ON -
      Indicat. Lamp Brake BRAKE warning light OFF or ON -
      Indicat. EPS EPS warning light OFF or ON -
      Master Warning Master warning light OFF or ON -
      Indicat. SET Cruise SET indicator light OFF or ON -
      Indicat. Radar Cruise*6 Radar cruise main indicator light OFF or ON -
      Indicat. Sport(CVT Sport)*3 SPORT indicator light OFF or ON -
      Indicat. VSC OFF VSC OFF indicator light OFF or ON -
      Indicat. ECO MODE*3 ECO MODE indicator light OFF or ON -
      Automatic High Beam Indicator*7 Automatic high beam indicator light OFF or ON -
      Turn Signal (Left) Indicator LH turn indicator light OFF or ON -
      Turn Signal (Right) Indicator RH turn indicator light OFF or ON -
      Check Engine Indicator MIL (Check engine warning light) OFF or ON -
      Water Temperature Meter Operation Engine coolant temperature receiver gauge OFF, LOW, NORMAL, HIGH -
      Meter Display 1 Multi-information display OFF or All -
      • *1: for Speedometer with Imperial Units
      • *2: for Speedometer with Metric Units
      • *3: w/ Shift Paddle Switch
      • *4: w/ Front Fog Light
      • *5: w/ Pre-collision System
      • *6: w/ Dynamic Radar Cruise Control System
      • *7: w/ Automatic High Beam System
scientia non olet · About LEMON Manuals