DTC C1AB7: Blind Spot Monitor Slave Module [10/2014 - ]: Procedure

1. Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
2. Recheck for DTCs and check if the same DTC is output again.

   OK

   No DTCs are output.

Result: 

OK 

USE SIMULATION METHOD TO CHECK 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] )

Result: 

NG 

REPLACE BLIND SPOT MONITOR SENSOR RH 

(Refer to REMOVAL [10/2014 - ] )