DTC C1AB6: Blind Spot Monitor Master Module [10/2014 - ]: Procedure

1. Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
2. Recheck for DTCs and check if the same DTC is output again.

   OK

   No DTCs are output.

Result: 

OK 

USE SIMULATION METHOD TO CHECK 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] )

Result: 

NG 

REPLACE BLIND SPOT MONITOR SENSOR LH 

(Refer to REMOVAL [10/2014 - ] )