DTC C1A47: Steering Angle Sensor [10/2014 - ]: Procedure

1. Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
2. Recheck for DTCs and check if the same DTC is output again.

   OK

   No DTCs are output.

Result: 

OK 

USE SIMULATION METHOD TO CHECK 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] )

Result: 

NG 

See step  2

1. Replace the spiral cable with sensor sub-assembly (Refer to REMOVAL [10/2014 - ] ).

Result: 

NEXT 

See step  3

1. Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
2. Recheck for DTCs and check if the same DTC is output again.

   Result

   Result	Proceed to
   No DTC is output	A
   DTC is output from the blind spot monitor sensor LH (master)	B
   DTC is output from the blind spot monitor sensor RH (slave)	C

Result: 

A 

END (SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY WAS DEFECTIVE) 

Result: 

B 

REPLACE BLIND SPOT MONITOR SENSOR LH 

(Refer to REMOVAL [10/2014 - ] )

Result: 

C 

REPLACE BLIND SPOT MONITOR SENSOR RH 

(Refer to REMOVAL [10/2014 - ] )