LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Avalon XLE Plus >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt Warning System - Diagnostic Codes & Symptom Tests - (Except Hybrid) >> Seat Belt Warning System >> Customize Parameters [10/2014 - ] >> Procedure

Customize Parameters [10/2014 - ]: Procedure

  1. CUSTOMIZE SEAT BELT WARNING SYSTEM 

    HINT: 

    The following items can be customized.

    NOTE:
    • When the customer requests a change in a function, first make sure that the function can be customized.
    • Be sure to make a note of the current settings before customizing.
    • When troubleshooting a function, first make sure that the function is set to the default setting.
    • These buzzers should be ON for safe driving. Perform this procedure only if it is necessary to set the buzzer to OFF (disabled).
    1. Customizing with the Techstream
      1. Connect the Techstream to the DLC3.
      2. Turn the engine switch is on (IG).
      3. Turn the Techstream on.
      4. Enter the following menus: Customize Setting / Warning.
      5. Select the setting by referring to the table below.
        WARNING

        Display Default Content Setting Relevant ECU
        Driver Side Seatbelt Warning Buzzer ON Function to sound the driver seat belt warning buzzer OFF/ON Combination meter assembly
        Front Passenger Side Seatbelt Warning Buzzer ON Function to sound the front passenger seat belt warning buzzer OFF/ON

        HINT: 

        This setting is only valid when the vehicle is driven at 20 km/h (12 mph) or more.

scientia non olet · About LEMON Manuals