Installation [10/2014 - ]: Procedure

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 2

1. Install 2 new gaskets to the front exhaust pipe assembly (TWC: Rear Catalyst).
2. Connect the front exhaust pipe assembly (TWC: Rear Catalyst) to the No. 1 exhaust pipe support bracket (for Rear Side).
3. Install the front exhaust pipe assembly (TWC: Rear Catalyst) with the 2 bolts and 2 nuts.

   Torque: 55 N*m (561 kgf*cm, 41 ft.*lbf) 

4. Connect the 2 heated oxygen sensor connectors.
5. Install the 2 wire harnesses to the clamp.

1. Install the No. 1 exhaust pipe support bracket (for Front Side) with the 2 nuts.

   Torque: 33 N*m (337 kgf*cm, 24 ft.*lbf) 

Refer to PROCEDURE - Step 88

Refer to PROCEDURE - Step 89

1. Install a new gasket to the front exhaust pipe assembly.
2. Connect the center exhaust pipe assembly to the 2 exhaust pipe supports.
3. Install the center exhaust pipe assembly with the 2 bolts and 2 nuts.

   Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf) 

1. Install the exhaust pipe damper with the 2 bolts.

   Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf) 

1. Install a new gasket to the center exhaust pipe assembly.
2. Connect the tail exhaust pipe assembly to the 3 exhaust pipe supports.
3. Install the tail exhaust pipe assembly with the 2 nuts.

   Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf) 

1. Install a new gasket to the center exhaust pipe assembly.
2. Connect the tail exhaust pipe LH to the 2 exhaust pipe supports.
3. Install the tail exhaust pipe LH with the 2 nuts.

   Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)