Inspection [10/2014 - ]: Procedure
- INSPECT MOBILE WIRELESS CHARGER SWITCH
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 11 (+B) - 8 (D) Mobile wireless charger switch is on (not protruding) Below 1 Ω Mobile wireless charger switch is off (protruding) 10 kΩ or higher TEXT IN ILLUSTRATION*a Component without harness connected
(Mobile Wireless Charger Switch)If the result is not as specified, replace the mobile wireless charger switch.
- Check that the switch indicator light illuminates.
- Apply battery voltage to the mobile wireless charger switch connector and check the operation of the switch indicator light.
OK
Connection Condition Specified Condition Battery positive (+) → Terminal 11 (+B)
Battery negative (-) → Terminal 12 (E)Mobile wireless charger switch is on (not protruding) Switch indicator light illuminates Mobile wireless charger switch is off (protruding) Switch indicator light does not illuminate TEXT IN ILLUSTRATION*a Component without harness connected
(Mobile Wireless Charger Switch)If the result is not as specified, replace the mobile wireless charger switch.
- Apply battery voltage to the mobile wireless charger switch connector and check the operation of the switch indicator light.
- Check that the switch illuminates.
- Apply battery voltage to the mobile wireless charger switch and check that the switch illuminates.
OK
Connection Specified Condition Battery positive (+) → Terminal 10 (ILL+)
Battery negative (-) → Terminal 9 (ILL-)Illuminates TEXT IN ILLUSTRATION*a Component without harness connected
(Mobile Wireless Charger Switch)If the result is not as specified, replace the mobile wireless charger switch.
- Apply battery voltage to the mobile wireless charger switch and check that the switch illuminates.
- Measure the resistance according to the value(s) in the table below.