Installation [10/2014 - ]: Procedure

INSTALL GENERATOR ASSEMBLY
1. Install the generator assembly with the 2 bolts.
  Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)
2. Connect the wire harness clamp to the generator bracket.
3. Install the generator bracket with the 2 bolts.
  Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
4. Install the wire harness clamp with the bolt.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
5. Connect the wire harness with the nut.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
6. Close the terminal cap.
7. Connect the connector.
INSTALL V-RIBBED BELT
(Refer to INSTALLATION [10/2014 - ] ).
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 82
INSTALL RADIATOR ASSEMBLY
(Refer to INSTALLATION [10/2014 - ] ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [10/2014 - 10/2015] or INITIALIZATION [10/2015 - ] ).