LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Avalon XLE Plus >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Rear) - Service Information - (Except Hybrid) >> Rear Brake >> Disassembly [10/2014 - ] >> Procedure

Disassembly [10/2014 - ]: Procedure

  1. REMOVE CYLINDER BOOT 
    1. Using a screwdriver with its tip wrapped with protective tape, remove the rear disc brake piston set ring and cylinder boot from the rear disc brake cylinder assembly.
      GTY549064Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Protective Tape
      NOTE:

      Be careful not to damage the rear disc brake piston or rear disc brake cylinder.

  2. REMOVE REAR DISC BRAKE PISTON 
    1. Place a piece of cloth between the rear disc brake piston and rear disc brake cylinder.
      GTY323151Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Apply compressed air to remove the rear disc brake piston from the rear disc brake cylinder.
      WARNING:

      Do not place your fingers in front of the rear disc brake piston when using compressed air.

      NOTE:

      Do not allow any brake fluid to spatter.

  3. REMOVE PISTON SEAL 
    1. Using a screwdriver with its tip wrapped with protective tape, remove the piston seal from the rear disc brake cylinder.
      GTY543207Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Protective Tape
      NOTE:

      Do not damage the inner surface or piston seal groove of the rear disc brake cylinder.

  4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP 
  5. REMOVE REAR DISC BRAKE BLEEDER PLUG 
scientia non olet · About LEMON Manuals