LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Avalon XLE Plus >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Hydraulic) - Service Information - (Except Hybrid) >> Brake Master Cylinder >> Reassembly [10/2014 - ] >> Procedure

Reassembly [10/2014 - ]: Procedure

  1. INSTALL MASTER CYLINDER RESERVOIR GROMMET 
    1. Apply a light layer of lithium soap base glycol grease to the entire circumference of 2 new master cylinder reservoir grommets.
    2. Install the 2 master cylinder reservoir grommets to the brake master cylinder reservoir assembly.
  2. INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY 
    1. Install the brake master cylinder reservoir assembly to the brake master cylinder assembly.
  3. INSTALL BRAKE MASTER CYLINDER RING PIN 
    1. Mount the brake master cylinder assembly in a vise.
      NOTE:
      • Place aluminum plates on the vise to prevent damage to the brake master cylinder assembly.
      • Do not drop the brake master cylinder reservoir assembly.
    2. Using a 5 mm pin punch and a hammer, tap in the brake master cylinder ring pin to secure the brake master cylinder reservoir assembly.
      GTY600924Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL BRAKE MASTER CYLINDER RESERVOIR STRAINER 
  5. INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY 
scientia non olet · About LEMON Manuals