LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Avalon XLE Plus >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Hydraulic) - Service Information - (Except Hybrid) >> Brake Master Cylinder >> Disassembly [10/2014 - ] >> Procedure

Disassembly [10/2014 - ]: Procedure

  1. REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY 
  2. REMOVE BRAKE MASTER CYLINDER RESERVOIR STRAINER 
  3. REMOVE BRAKE MASTER CYLINDER RING PIN 
    1. Mount the brake master cylinder sub-assembly in a vise.
      NOTE:

      Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.

    2. Using a 5 mm pin punch and a hammer, tap out the brake master cylinder ring pin from the brake master cylinder sub-assembly.
      GTY600924Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Do not drop the brake master cylinder reservoir sub-assembly.

  4. REMOVE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY 
    1. Remove the brake master cylinder reservoir assembly from the brake master cylinder assembly.
  5. REMOVE MASTER CYLINDER RESERVOIR GROMMET 
    1. Remove the 2 master cylinder reservoir grommets from the brake master cylinder reservoir assembly.
scientia non olet · About LEMON Manuals