Caution / Notice / Hint
NOTE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When the sliding roof ECU (sliding roof drive gear assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear assembly) must be initialized (Refer to INITIALIZATION [10/2014 - ] ).
- The sliding roof system uses the CAN and LIN communication systems. First, confirm that there are no malfunctions in the CAN and LIN communication systems. Refer to How to Proceed with Troubleshooting (Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] or HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] ).
- When a sliding roof ECU (sliding roof drive gear assembly) DTC is output, first perform troubleshooting for the sliding roof ECU (sliding roof drive gear assembly) DTC.