LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Avalon XLE Plus >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) (Service Information) (Except Hybrid) >> Luggage Compartment Door Opener Inner Switch >> Inspection [10/2014 - ] >> Procedure

Inspection [10/2014 - ]: Procedure

  1. INSPECT LUGGAGE COMPARTMENT DOOR OPENING SWITCH ASSEMBLY 
    1. Check the resistance.
      GTY366722Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        4 (B) - 1 (L) Switch off 10 kΩ or higher
        Switch on Below 1 Ω

        If the result is not as specified, replace the luggage door opening switch assembly.

    2. Inspect the illumination.
      1. Apply battery voltage to the luggage door opening switch assembly connector, and check that the luggage door opening switch assembly LED illuminates.

        OK

        Measurement Condition Specified Condition
        Battery positive (+) → Terminal 3 (ILL+)
        Battery negative (-) → Terminal 2 (ILL-)        		 LED illuminates

        If the result is not as specified, replace the luggage door opening switch assembly.

        TEXT IN ILLUSTRATION

        *a Component without harness connected
        (Luggage Door Opening Switch Assembly)
scientia non olet · About LEMON Manuals