Removal [10/2014 - ]: Procedure
- REMOVE SPOT LIGHT ASSEMBLY
- Using a screwdriver with its tip wrapped with protective tape, disengage the 8 claws to remove the 2 spot light lenses.TEXT IN ILLUSTRATION
*a Protective Tape *b Front - Using a screwdriver with its tip wrapped with protective tape and a moulding remover, disengage the 2 claws (A).TEXT IN ILLUSTRATION
*a Protective Tape *b Claw (A) *c Claw (B) *d Claw (C) *e Front - Disengage the 2 claws (B) and 2 claws (C) to disconnect the spot light housing.
- Using a screwdriver, disengage the 8 claws and 2 clamps to separate the 2 map light sub-assemblies from the spot light housing.TEXT IN ILLUSTRATION
*1 Map Light Sub-assembly
- Using a screwdriver with its tip wrapped with protective tape, disengage the 8 claws to remove the 2 spot light lenses.
- REMOVE SPOT LIGHT BULB
- Remove the 2 spot light bulbs from the 2 map light sub-assemblies.