How To Proceed With Troubleshooting [10/2014 - 10/2015]: Procedure

Result

NEXT 

See step  2

1. Interview the customer to confirm the trouble Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] ).

   Result

   Proceed to
   NEXT

NEXT 

See step  3

1. Measure the battery voltage.

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

   Result

   Proceed to
   NEXT

NEXT 

See step  4

1. Using the Techstream, check if the CAN communication system is functioning normally Refer to DIAGNOSIS SYSTEM [10/2014 - 10/2015] ).

   Result

   Result	Proceed to
   CAN DTCs are not output	A
   CAN DTCs are output	B

Result: 

B 

Refer to CAN COMMUNICATION SYSTEM 

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] )

Result: 

A 

See step  5

1. Check that the operation of the shift indicator on the combination meter assembly.

   OK

   The shift indicator on the combination meter assembly operates normally.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

Refer to METER / GAUGE SYSTEM 

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] )

Result: 

OK 

See step  6

1. Refer to Problem Symptoms Table Refer to PROBLEM SYMPTOMS TABLE [10/2014 - ] ).

   Result

   Result	Proceed to
   Fault not listed in problem symptoms table	A
   Fault listed in problem symptoms table	B

Result: 

B 

See step  8

Result: 

A 

See step  7

1. Terminals of ECU Refer to TERMINALS OF ECU [10/2014 - ] )
2. Operation Check Refer to OPERATION CHECK [10/2014 - ] )
3. Data List / Active Test Refer to DATA LIST / ACTIVE TEST [10/2014 - ] )

   Result

   Proceed to
   NEXT

NEXT 

See step  8

Result

NEXT 

See step  9

Result

NEXT 

END