LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Avalon XLE Plus >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting System (Ext) - Service Information - (Except Hybrid) >> Stop Light Switch >> Installation [10/2014 - ] >> Procedure

Installation [10/2014 - ]: Procedure

  1. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER 
    1. Engage the 2 claws to install the stop light switch mounting adjuster.
  2. INSTALL STOP LIGHT SWITCH ASSEMBLY 
    1. Insert the stop light switch assembly until the threaded sleeve hits the pedal.
      GTY247461Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    2. Turn the stop light switch assembly a quarter turn clockwise to install the stop light switch assembly.
      GTY560368Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf) 

      or less

      NOTE:

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    3. Connect the connector.
    4. Check the protrusion of the plunger.
      PROTRUSION OF THE PLUNGER

      Area Measurement
      a 1.5 to 2.5 mm (0.0591 to 0.0984 in.)

      If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary (Refer to ADJUSTMENT [10/2014 - ] ).

      NOTE:

      Do not depress or support the brake pedal.

scientia non olet · About LEMON Manuals