LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> 86 Base, Automatic Trans >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Diagnostic Codes & Symptom Tests >> Meter / Gauge System >> Malfunction in Water Temperature Warning Light [03/2017 - ] >> Procedure

Malfunction in Water Temperature Warning Light [03/2017 - ]: Procedure

  1. CHECK FOR DTC (METER / GAUGE SYSTEM) 
    1. Check if meter / gauge system DTCs are output (Refer to DTC CHECK / CLEAR [06/2016 - ] ).

      OK

      DTCs are not output.

    Result: 

    NG 

    GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [06/2016 - ] 

    Result: 

    OK 

    See step  2

  2. CHECK FOR DTC (SFI SYSTEM) 
    1. Check if SFI system DTCs are output (Refer to DTC CHECK / CLEAR [06/2016 - ] ).

      OK

      DTCs are not output.

    Result: 

    NG 

    GO TO SFI SYSTEM. Refer to  DIAGNOSTIC TROUBLE CODE CHART [03/2017 - 07/2018]  Refer to  DIAGNOSTIC TROUBLE CODE CHART [07/2018 - ] 

    Result: 

    OK 

    See step  3

  3. CHECK TELLTALE LIGHT (WATER TEMPERATURE WARNING (COLD)) 
    1. Disconnect the C40 engine coolant temperature sensor connector.
      GTY723838Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Engine Coolant Temperature Sensor
      *2 ECM
    2. Turn the ignition switch to ON.
    3. Check the operating condition of the water temperature warning light.

      Result

      Result Proceed to
      Water temperature warning light (blue) is on. A
      Water temperature warning light (blue) is not on. B

    Result: 

    B 

    REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [03/2017 - ] 

    Result: 

    A 

    See step  4

  4. CHECK TELLTALE LIGHT (WATER TEMPERATURE WARNING (HOT)) 
    1. Disconnect the C40 engine coolant temperature sensor connector.
    2. Connect terminals 1 and 2 of the C40 engine coolant temperature sensor connector on the wire harness side.
      GTY701456Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Engine Coolant Temperature Sensor
      *2 ECM
      *a Front view of wire harness connector
      (to Engine Coolant Temperature Sensor)
    3. Turn the ignition switch to ON.
    4. Check the operating condition of the water temperature warning light.

      Result

      Result Proceed to
      Water temperature warning light (red) is on. A
      Water temperature warning light (red) is not on. B

    Result: 

    B 

    REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [03/2017 - ] 

    Result: 

    A 

    See step  5

  5. INSPECT ENGINE COOLANT TEMPERATURE SENSOR 
    1. Inspect the engine coolant temperature sensor (Refer to INSPECTION [06/2016 - ] ).

    Result: 

    OK 

    REPLACE ECM. Refer to  REMOVAL [06/2016 - ] 

    Result: 

    NG 

    REPLACE ENGINE COOLANT TEMPERATURE SENSOR. Refer to  REMOVAL [06/2016 - ]