Entire Combination Meter does not Operate [06/2016 - ]: Procedure

1. Disconnect the D7 combination meter assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   D7-1 (B) - Body ground	Always	11 to 14 V
   D7-2 (IG+) - Body ground	Ignition switch ON	11 to 14 V

3. Measure the resistance according to the value in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D7-20 (ES1) - Body ground	Always	Below 1 Ω
   D7-40 (ES2) - Body ground	Always	Below 1 Ω

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Combination Meter Assembly)

4. Reconnect the D7 combination meter assembly connector.

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY 

(Refer to REMOVAL [06/2016 - 03/2017] Refer to REMOVAL [03/2017 - ] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR