Slip Indicator Light does not Come ON [08/2015 - 08/2019]: Procedure

See step  1

Result: 

B 

CHECK CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] )

Result: 

A 

See step  2

1. Turn the ignition switch off.
2. Connect the Techstream to the DLC3.
3. Turn the ignition switch to ON.
4. Turn the Techstream on.
5. Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
6. According to the display on the Techstream, perform the Active Test.
   ABS/VSC/TRAC
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Slip Indicator Light	Slip indicator light	Indicator light ON/OFF	Observe combination meter assembly Vehicle condition: Vehicle stopped

7. When performing the Slip Indicator Light Active Test, check Slip Indicator Light in the Data List.
   ABS/VSC/TRAC
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Slip Indicator Light	Slip Indicator Light / ON or OFF	ON: Indicator light on OFF: Indicator light off	-

   Result

   Result	Proceed to
   Slip indicator light in the Data List turns ON/OFF using the Active Test	A
   Slip indicator light in the Data List does not change using the Active Test	B

Result: 

B 

REPLACE BRAKE ACTUATOR ASSEMBLY 

(Refer to REMOVAL [08/2015 - 08/2019] )

Result: 

A 

See step  3

1. Turn the ignition switch off.
2. Perform Active Test of the combination meter assembly using the Techstream (Refer to DATA LIST / ACTIVE TEST [08/2015 - 08/2019] ).
3. Check the combination meter assembly.

   OK

   The slip indicator light turns on or off in accordance with the Techstream.

Result: 

OK 

REPLACE BRAKE ACTUATOR ASSEMBLY 

(Refer to REMOVAL [08/2015 - 08/2019] )

Result: 

NG 

INSPECT METER / GAUGE SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] )