Slip Indicator Light Remains ON [08/2019 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Using the Techstream, check for Vehicle Control History.

   Refer to VEHICLE CONTROL HISTORY [08/2019 - ]

   CHASSIS > BRAKE > UTILITY
   
   

   Tester Display
   Vehicle Control History (RoB)

   HINT: 

   If vehicle control history is stored (X2079, X2088, X208A, X20D7, X20D8, X204C), the slip indicator light illuminates.

   Result

   Result	Proceed to
   No vehicle control history (X2079, X2088, X208A, X20D7, X20D8, X204C)	A
   Vehicle control history exists (X2079, X2088, X208A, X20D7, X20D8, X204C)	B

Result: 

B 

PERFORM TROUBLESHOOTING AND REPAIR REGARDING VEHICLE CONTROL HISTORY 

Refer to VEHICLE CONTROL HISTORY [08/2019 - ]

Result: 

A 

See step  2

1. Perform Active Test of the combination meter assembly using the Techstream.
   BODY ELECTRICAL > COMBINATION METER > ACTIVE TEST
   
   

   Tester Display
   Indicat. Lamp Slip

2. Check the combination meter assembly.

   OK

   The slip indicator light turns on or off in accordance with the Techstream.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE BRAKE ACTUATOR ASSEMBLY. Refer to  REMOVAL [08/2019 - ] 

Result: 

NG 

INSPECT METER / GAUGE SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ]