Caution / Notice / Hint

NOTE:

After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
Refer to CALIBRATION [08/2019 - ]
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:

When C137B-A2 and/or C137B-A3 is output together with C143A-7E and/or C143A-7F, inspect and repair the trouble areas indicated by C137B-A2 and/or C137B-A3 first.

for C137B-A2: Refer to DTC C137B-A2: Brake System Control Module "A" System Voltage System Voltage Low [08/2019 - ]

for C137B-A3: Refer to DTC C137B-A3: Brake System Control Module "A" System Voltage System Voltage High [08/2019 - ]