ABS Warning Light does not Come ON [08/2015 - 08/2019]: Procedure

See step  1

Result: 

B 

CHECK CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] )

Result: 

A 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch off.
3. Turn the Techstream on.
4. Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
5. According to the display on the Techstream, perform the Active Test.
   ABS/VSC/TRAC
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   ABS Warning Light	ABS warning light	Warning light OFF/ON	Observe combination meter assembly Vehicle condition: Vehicle stopped

6. When performing the ABS Warning Light Active Test, check ABS Warning Light in the Data List.
   ABS/VSC/TRAC
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   ABS Warning Light	ABS warning light / ON or OFF	ON: Warning light on OFF: Warning light off	-

   Result

   Result	Proceed to
   ABS warning light in the Data List turns ON/OFF using the Active Test	A
   ABS warning light in the Data List does not change using the Active Test	B

Result: 

B 

REPLACE BRAKE ACTUATOR ASSEMBLY 

(Refer to REMOVAL [08/2015 - 08/2019] )

Result: 

A 

See step  3

1. Turn the ignition switch off.
2. Perform Active Test of the combination meter assembly using the Techstream (Refer to DATA LIST / ACTIVE TEST [08/2015 - 08/2019] ).
3. Check the combination meter assembly.

   OK

   The ABS warning light turns on or off in accordance with the Techstream.

Result: 

OK 

REPLACE BRAKE ACTUATOR ASSEMBLY 

(Refer to REMOVAL [08/2015 - 08/2019] )

Result: 

NG 

INSPECT METER / GAUGE SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] )