TS and CG Terminal Circuit [08/2015 - 08/2019]: Procedure

1. Turn the ignition switch off.
2. Disconnect the A6 skid control ECU connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A6-24 (TS) - F13-12 (TS)	Always	Below 1 Ω

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F13-4 (CG) - Body ground	Always	Below 1 Ω

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  3

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F13-12 (TS) - Body ground	Always	10 kΩ or higher

Result: 

OK 

REPLACE MASTER CYLINDER SOLENOID 

(Refer to DISASSEMBLY [08/2015 - ] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR