AUTO LSD Indicator Light does not Come ON [08/2015 - ]: Procedure

1. Turn the ignition switch off.
2. Connect the Techstream to the DLC3.
3. Turn the ignition switch to ON.
4. Turn the Techstream on.
5. Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Refer to DIAGNOSIS SYSTEM [08/2015 - 08/2019] , or refer to DIAGNOSIS SYSTEM [08/2019 - 08/2021] , or refer to DIAGNOSIS SYSTEM [08/2021 - 08/2022] , or refer to DIAGNOSIS SYSTEM [08/2022 - ] ).

   OK

   CAN Bus Check indicates no malfunctions in CAN communication.

Result: 

NG 

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2019 - ] )

Result: 

OK 

See step  2

See step  6[08/2015 - 08/2019], or see step  6[08/2019 - ]

Result: 

NG 

REPLACE VSC OFF SWITCH 

(Refer to REMOVAL [08/2015 - ] )

Result: 

OK 

See step  3

See step  7[08/2015 - 08/2019], or see step  7[08/2019 - ]

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  4

See step  4

Result: 

A 

REPLACE MASTER CYLINDER SOLENOID 

(Refer to DISASSEMBLY [08/2015 - ] )

Result: 

B 

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] )