DTC C0226: SFR Solenoid Circuit; DTC C0236: SFL Solenoid Circuit; DTC C0246: SRR Solenoid Circuit; DTC C0256: SRL Solenoid Circuit; DTC C1225: SM Solenoid Circuit; DTC C1226: SA2 Solenoid Circuit; DTC C1227: SA3 Solenoid Circuit; DTC C1228: STR Solenoid Circuit [08/2015 - 08/2019]: Procedure

HINT: 

These codes are stored when a problem is detected in the master cylinder solenoid.

The solenoid circuit is in the master cylinder solenoid.

Therefore, solenoid circuit inspections and solenoid unit inspections cannot be performed. Be sure to check if any DTC is output before replacing the master cylinder solenoid.

1. Clear the DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).
2. Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.
3. Check if the same DTCs are output (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).
   RESULT
   
   

   Result	Proceed to
   DTC is output	A
   DTC is not output	B

Result: 

A 

REPLACE MASTER CYLINDER SOLENOID 

(Refer to DISASSEMBLY [08/2015 - ] )

Result: 

B 

USE SIMULATION METHOD TO CHECK 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] )