Problem Symptoms Table [08/2019 - ]
NOTE:
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
HINT:
- The following problem symptoms table is based on the assumption that each system related to the combination meter assembly is normal.
- Refer to System Description for details about the communication between the combination meter assembly and each ECU.
Refer to SYSTEM DESCRIPTION [08/2019 - 08/2021] , or refer to SYSTEM DESCRIPTION [08/2021 - 08/2022] , or refer to SYSTEM DESCRIPTION [08/2022 - ]
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
METER OR GAUGE
| Symptom | Suspected Area | Link |
|---|---|---|
| Entire combination meter assembly does not operate | Power source circuit | Refer to Entire Combination Meter does not Operate [08/2019 - ] |
| Speedometer malfunction | Speedometer circuit | Refer to Speedometer Malfunction [08/2015 - ] |
| Tachometer malfunction | Tachometer circuit | Refer to Tachometer Malfunction [08/2015 - ] |
| Fuel receiver gauge display malfunction | Fuel receiver gauge display circuit | Refer to Fuel Receiver Gauge Malfunction [08/2019 - ] |
| Engine coolant temperature receiver gauge malfunction | Engine coolant temperature receiver gauge circuit | Refer to Engine Coolant Temperature Receiver Gauge Malfunction [08/2019 - 08/2021] , or refer to Engine Coolant Temperature Receiver Gauge Malfunction [08/2021 - ] |
WARNING OR INDICATOR
| Symptom | Suspected Area | Link |
|---|---|---|
| Fuel level warning light malfunction (Fuel receiver gauge is normal) | Combination meter assembly | Refer to REMOVAL [08/2015 - 08/2022] , or refer to REMOVAL [08/2022 - ] |
| Malfunction other than above | Combination meter assembly | Refer to REMOVAL [08/2015 - 08/2022] , or refer to REMOVAL [08/2022 - ] |
MULTI-INFORMATION DISPLAY
| Symptom | Suspected Area | Link |
|---|---|---|
| Multi-information display is not displayed | Combination meter assembly | Refer to REMOVAL [08/2015 - 08/2022] , or refer to REMOVAL [08/2022 - ] |
| Speedometer malfunction | Speedometer circuit | Refer to Speedometer Malfunction [08/2015 - ] |
| Windshield Washer Fluid Low display malfunction | Washer fluid level warning switch circuit | Refer to Washer Fluid Level Warning Switch Circuit [08/2019 - ] |
| Fuel Low display malfunction | Fuel receiver gauge display circuit | Refer to Fuel Receiver Gauge Malfunction [08/2019 - ] |
| Malfunction other than above | Combination meter assembly | Refer to REMOVAL [08/2015 - 08/2022] , or refer to REMOVAL [08/2022 - ] |
BUZZER
| Symptom | Suspected Area | Link |
|---|---|---|
| Buzzer malfunction | Combination meter assembly | Refer to REMOVAL [08/2015 - 08/2022] , or refer to REMOVAL [08/2022 - ] |
OTHERS
| Symptom | Suspected Area | Link |
|---|---|---|
| Operating light control rheostat does not change light brightness | Light control rheostat circuit | Refer to Operating Light Control Rheostat does not Change Light Brightness [08/2019 - ] |
| Meter illumination is always dark | Meter illumination circuit | Refer to Meter Illumination is Always Dark [08/2019 - ] |
| Meter illumination does not dim at night | Meter illumination circuit | Refer to Meter Illumination does not Dim at Night [08/2019 - ] |
| Other systems that use the speed signal do not operate normally | Speed signal circuit | Refer to Speed Signal Circuit [08/2019 - 08/2022] , or refer to Speed Signal Circuit [08/2022 - ] |
| Accessory meter assembly does not illuminate | Wire harness or connector | - |
| Accessory meter assembly | Refer to REMOVAL [08/2019 - ] | |
| Customization cannot be performed by setting customize settings on the setting tab of the multi-information display | Combination meter assembly | Refer to REMOVAL [08/2015 - 08/2022] , or refer to REMOVAL [08/2022 - ] |