Meter Illumination is Always Dark [08/2015 - 08/2019]: Procedure

1. Check if a CAN communication DTC is output. (Refer to DIAGNOSIS SYSTEM [08/2015 - 08/2019] ).
   RESULT
   
   

   Result	Proceed to
   CAN communication DTC is not output	A
   CAN communication DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] )

Result: 

A 

See step  2

1. Check if DTC B1244 is output. (Refer to DTC CHECK / CLEAR [08/2015 - ] ).
   RESULT
   
   

   Result	Proceed to
   B1244 is not output	A
   B1244 is output	B

Result: 

B 

GO TO LIGHTING SYSTEM 

(Refer to DTC B1244: Light Sensor Circuit Malfunction [08/2015 - 08/2019] )

Result: 

A 

See step  3

1. Turn the ignition switch to ON.
2. Turn the light control switch to the tail, head or AUTO position.
3. Cover the automatic light control sensor.
4. Check the heater control panel illumination.
   RESULT
   
   

   Result	Proceed to
   Heater control panel illumination does not operate normally	A
   Heater control panel illumination operates normally	B

   HINT: 

   Both the heater control panel and combination meter assembly illumination dim according to the dimmer signal. Therefore, when only the meter illumination is always dark, there may be a malfunction in the combination meter assembly.

Result: 

B 

REPLACE COMBINATION METER ASSEMBLY 

(Refer to REMOVAL [08/2015 - 08/2022] )

Result: 

A 

See step  4

1. Turn the ignition switch to ON.
2. Turn the light control switch to the AUTO position.
3. Cover the automatic light control sensor.
4. Check the taillights and low beam headlights.

   OK

   The taillights and low beam headlights come on.

5. Uncover the automatic light control sensor.
6. Check the low beam headlights and taillights.

   OK

   The taillights and low beam headlights go off.

   RESULT
   
   

   Result	Proceed to
   Automatic light control system operates normally	A
   Automatic light control system does not operate normally	B

Result: 

B 

GO TO LIGHTING SETTING 

(Refer to CUSTOMIZE PARAMETERS [08/2015 - 08/2019] )

Result: 

A 

See step  5

1. Replace the main body ECU with a new or normally functioning one. (Refer to REMOVAL [08/2015 - 08/2019] ).

   OK

   The operation of the combination meter assembly returns to normal.

   HINT: 

   The meter CPU controls the meter illumination based on an auto dimmer signal from the main body ECU. When the meter illumination is always dark (very dim), it may be due to the main body ECU sending an auto dimmer signal to the meter CPU because of a malfunction in the main body ECU.

Result: 

OK 

END 

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY 

(Refer to REMOVAL [08/2015 - 08/2022] )