Entire Combination Meter does not Operate [08/2015 - 08/2019]: Procedure

1. Disconnect the F14 meter connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F14-20 (E1) - Body ground	Always	Below 1 Ω
   F14-13 (MGND) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   F14-17 (IG+) - Body ground	Ignition switch ON	11 to 14 V
   F14-15 (B) - Body ground	Always	11 to 14 V

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Combination Meter Assembly)

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY 

(Refer to REMOVAL [08/2015 - 08/2022] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR