LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 XLE, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seats (Service Information) (Except Hybrid) (1 Of 2) >> FRONT SEAT ASSEMBLY (for Power Seat) >> Removal [12/2012 - ] >> Procedure

Removal [12/2012 - ]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing.

    Refer to PRECAUTION [12/2012 - ]

    NOTE:
    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

      Refer to PRECAUTION [12/2012 - ]

    • If the side airbag has deployed, replace the front seat airbag assembly LH, separate type front seatback spring assembly LH, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.
  2. REMOVE FRONT SEAT HEADREST ASSEMBLY 
    1. Remove the front seat headrest assembly.
  3. REMOVE FRONT OUTER SEAT TRACK BRACKET COVER LH 
    1. Operate the front power seat switch (slide switch) to move the seat to the rearmost position.
    2. Detach the 2 claws to remove the front outer seat track bracket cover LH as indicated by the arrows in the order shown in the illustration.
      GTY366833Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      First
      Second
  4. REMOVE FRONT INNER SEAT TRACK BRACKET COVER LH 
    1. Detach the 2 claws to remove the front inner seat track bracket cover LH as indicated by the arrows in the order shown in the illustration.
      GTY363841Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      First
      Second
  5. REMOVE REAR OUTER SEAT TRACK BRACKET COVER LH 
    1. Operate the front power seat switch (slide switch) to move the seat to the foremost position.
    2. Detach the 2 claws to remove the rear outer seat track bracket cover LH as indicated by the arrows in the order shown in the illustration.
      GTY379042Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      First
      Second
  6. REMOVE REAR INNER SEAT TRACK BRACKET COVER LH 
    1. Detach the 2 claws to remove the rear inner seat track bracket cover LH as indicated by the arrows in the order shown in the illustration.
      GTY379572Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      First
      Second
  7. REMOVE FRONT SEAT ASSEMBLY LH 
    1. Remove the 2 bolts.
      GTY381190Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Operate the front power seat switch (slide switch) to move the seat to the rearmost position.
    3. Remove the 2 bolts.
      GTY361140Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Operate the front power seat switch (slide switch) to align the front side of the inner adjuster with the front side of the outer adjuster.
    5. Disconnect the cable from negative (-) battery terminal.
      WARNING:

      Wait at least 90 seconds after disconnecting the cable from the battery negative (-) terminal to disable the SRS system.

      NOTE:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Refer to INITIALIZATION [12/2012 - 10/2015] , or refer to INITIALIZATION [10/2015 - 08/2016] , or refer to INITIALIZATION [08/2016 - ]

    6. Detach the 2 clamps and disconnect the connector of the front seat inner belt assembly LH.
      GTY361143Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Disconnect the connector of the seat heater.
    8. Disconnect the connector of the front seat airbag assembly LH.
      1. Place a finger on the slider, slide the slider to release the lock, and then disconnect the front seat airbag connector.
        GTY365623Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *1 Slider - -
    9. Remove the front seat assembly LH from the vehicle.
      NOTE:

      Be careful not to damage the vehicle body.

scientia non olet · About LEMON Manuals