Inspection [10/2015 - ]: Procedure
- INSPECT REAR COMBINATION LIGHT ASSEMBLY LH (for LED Type Tail and Stop Light)
- Apply battery voltage to the connector and check the light illumination condition.
*a Component without harness connected
(Rear Combination Light assembly LH)OK
Condition Specified Condition Battery positive (+) → N13-2 (B)
Battery negative (-) → N13-4 (E)Taillight and rear side marker light illuminates Battery positive (+) → N13-1 (B)
Battery negative (-) → N13-4 (E)Stop light illuminates If the result is not as specified, replace the rear combination light assembly LH.
- Apply battery voltage to the connector and check the light illumination condition.
- INSPECT REAR COMBINATION LIGHT ASSEMBLY RH (for LED Type Tail and Stop Light)
- Apply battery voltage to the connector and check the light illumination condition.
*a Component without harness connected
(Rear Combination Light assembly RH)OK
Condition Specified Condition Battery positive (+) → M19-2 (B)
Battery negative (-) → M19-4 (E)Taillight and rear side marker light illuminates Battery positive (+) → M19-1 (B)
Battery negative (-) → M19-4 (E)Stop light illuminates If the result is not as specified, replace the rear combination light assembly RH.
- Apply battery voltage to the connector and check the light illumination condition.