Inspection [12/2012 - ]: Procedure
- INSPECT TELLTALE LIGHT ASSEMBLY (HAZARD WARNING SWITCH)
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Switch Condition Specified Condition 7 (TB) - 13 (E) Hazard warning signal switch off 10 kΩ or higher Hazard warning signal switch on Below 1 Ω If the result is not as specified, replace the telltale light assembly (hazard warning switch).
*a Component without harness connected
(Telltale Light Assembly (Hazard Warning Switch))
- Measure the resistance according to the value(s) in the table below.